Introduction

How to remove an Airsoft AEG from a stock fan in a short time and remove the exhaust fan from your Airsoft rifle

The stock airsoft airsoft exhaust fan can cause a lot of issues with the gun.

In the past, there was a fair amount of confusion over which exhaust fan to get when purchasing an airsoft rifle.

Thankfully, we’ve got a quick and easy fix to remove the stock aircooled fan from an airgun.

First off, you’ll need to make sure that the stock exhaust fan is removed from the gun (just remove the cover).

Next, remove the old fan from the rifle.

Then, you can pop out the new one.

The new fan is a metal piece that sits on the rear of the exhaust pipe.

It will be located in a small hole.

There is a small opening on the side of the fan that you will need to unscrew to remove it.

Now, pop out a small piece of paper towel and remove a piece of plastic wrap.

This piece of cardboard is going to act as a guide as you remove the fan.

Next, pull the plastic wrap off of the back of the airsoft gun.

Next you’ll have to pull out the exhaust airflow sensor.

Now that you’ve removed the exhaust fans, it’s time to pop the fans out of the gun and into your new rifle.

You can do this by removing the stock fan and pulling the fan out.

This will also loosen the plastic on the fan, allowing you to remove and replace the fan without damaging it.

Once you’re done with the fan removal, you should have a clean, fresh stock airgun without any issues.

Next, take the stock and install a new exhaust fan.

There are many options for this, so check with your local Airsoft retailer for the best fit.

There will be a rubber gasket on the top of the stock fans, so you can install it with a screwdriver.

The stock fan should fit perfectly.

The only issue you may have is that the rubber gaskets on the fans will not line up.

The gasket will need some adjustment to fit the fan properly.

After the fan is installed, take your stock fan apart and install the new fan.

You will need a screw driver to get the rubber to line up perfectly.

Make sure to get some of the excess rubber out of your new fan before you install the fans.

Make the adjustment as necessary to ensure the fan line up properly.

Now you should be able to remove your stock exhaust fans from your gun and remove all of the new exhaust fans.

The last thing you want to do with an Airgun is remove the new stock air cooled exhaust fan and replace it with your new one from scratch.

This is what we do when we get our stock exhaust to do a few things.

It allows us to run an empty battery, but also allows us a clean install of the gearbox, motor, and gun.

You should be using an empty Battery Pack now, and the new engine will be ready to go in a couple hours.

If you are going to replace the stock motor and gearbox as well, it may take up to two weeks to install the motor and motor and the gearboxes.

After that time, the Airsoft gearbox and motor will be completely stock.

You’ll have a new stock Airsoft Gearbox that will fit perfectly in your Airgun.

The airsoft gearboxes are very reliable, but it may be time for you to upgrade your rifle.

When you purchase an Airshot rifle, you are getting a complete rebuild of the rifle and gun, replacing the stock, and replacing the gear box.

This makes it easy to upgrade a rifle to an upgraded build.

In addition, there are some upgrades that can be made to your rifle, depending on your needs.

For example, if you are using a different airsoft A.E. engine, you may want to upgrade the motor.

There have been a few popular Airsoft motors that are compatible with the Airshot rifles.

If your rifle is not compatible with a specific motor, you could look into an AirShot upgrade kit.

The Airshot AEG kits are the most popular upgrade kits for the AirShot AEG.

You may also be able forgo upgrading your rifle altogether, depending if you have a good battery or are a beginner to Airsoft.